Executive Editor: Chris Colton

Authors: Florian Gebhard, Phil Kregor, Chris Oliver

Distal femur Extraarticular fracture, avulsion

back to skeleton


1 Principles top


Injury types

Avulsion fractures can result from mild to moderate injury to the knee. Twisting injuries to the knee may result in major ligament disruptions of the medial collateral, or anterior or posterior cruciate ligaments (PCL). It is most commonly the medial collateral (MCL) and the anterior cruciate ligament (ACL) that are injured. Patients with an anterior cruciate ligament disruption will sometimes report a popping sensation from the knee at the time of injury. A rapid early hemarthrosis will develop with an anterior cruciate ligament injury. Anterior cruciate ligament injuries most commonly occur in young patients, who partake in sporting activities. Small avulsion fractures may represent markers or significant injuries to the knee, such as multiligamentous knee dislocation. MRI can detect significant ligament damage. Consultation and advice from specialist knee reconstructive surgeons may need to sought.

Fixation of these important ligamentous avulsion fractures is essential to knee joint stability, especially in association with intra-substance ligament injuries. Healing in displacement results in joint stiffness and laxity.


Pellegrini-Stieda lesion

Long-term effects of avulsion of the medial collateral ligament from its femoral attachment, causing local pain and heterotopic ossification, comprise the “Pellegrini-Stieda” lesion.

Segond fracture

Avulsion of the lateral collateral ligament from the distal femur with a small piece of bone is known as the “Segond” fracture. “Segond” fractures may accompany serious injuries to the knee. There may be peroneal nerve, or menisceal, injuries.

Similar principles apply to the fracture treatment on both the lateral and medial side of the distal femur. In the following we will show the medial avulsion injury.


Lag screw fixation

The avulsion fracture is reduced and compressed using the lag screw principle.


Use of washers to affix ligament

To secure the ligaments and small, thin fragments, a special ligament washer can be used on the screw. These washers are made of either metal, or plastic material.

2 Patient preparation and approaches top

This procedure may be performed with the patient in one of the following positions:

3 Approaches top

For avulsion fractures from the lateral epicondyle, the lower end of the  MIO lateral/anterolateral approach is used.

For similar medial fractures, a direct medial approach is used, deepened cautiously to expose the medial face of the medial condyle. Care is taken to avoid the saphenous nerve and its infrapatellar branch.

4 Reduction top


Large pointed reduction forceps

Reduce the fracture with a large pointed reduction forceps. Small thin fragments may fracture if such a forceps is applied, and reduction and control with a dental pick may be preferable. The fracture is then secured with a temporary K-wire, taking care not to conflict with the proposed screw track.


Drill hole for the lag screw

The forceps are then removed, and the hole for the lag screw is drilled through the center of the avulsed fragment.

5 Fixation top

Lag screw enlarge

Insert a lag screw with or without a ligament washer.

A cannulated screw can be used if available.

Gently examine the knee under anesthesia to test for ligament instability. Be careful not to stress too heavily the reattached ligament.

v1.0 2008-12-03