1 Introduction top
Based on CT and MRI imaging, a plan should be prepared to determine:
- The size and optimal location of implants used
- Whether spinal cord decompression is necessary and if so, the amount of tissue to remove in order to achieve sufficient spinal cord decompression
Every case will be unique, and we will here illustrate just one example.
Use of dexamethasone
Administration of dexamethasone (10 mg bolus, 4 mg every 6 hours) is recommended as soon as ESCC causing neurologic deficit is diagnosed. Dexamethasone should be stopped or tapered as soon as spinal cord decompression is completed.
Embolization procedures are recommended to reduce operative blood loss in hyper vascular tumors. , especially for larger resections.
The preoperative neurological assessment must be carried out as described in the Neurological Evaluation.
2 Patient positioning and surgical approach topenlarge
3 Instrumentation topenlarge
Posterior instrumentation should normally include two levels above and two to three below the affected vertebra.
If C1 instrumentation is indicated lateral mass screws are used.
For C2 fixation the following options are available (in order of preference):
A consideration is given to use pedicle or laminar screws when doing an occiput to C2 fusion as oftentimes the starting point for the pars screws may compromise the facet joint.
Lateral mass screws vs. pedicle screws C3-C7
Fixation can be achieved with either lateral mass screws, pedicle screws or combination of the two.
Because lateral mass fixation is generally sufficient, and carries less risk, pedicle screw fixation is limited to rare cases where lateral mass fixation would be insufficient or not possible. A pedicle screw is most often used in C7 if instrumented.
4 Rod insertion topenlarge
The rod should be bent to align with the lordosis achieved during positioning.
The rod is inserted into the screw heads and the screw heads are tightened with the inner nuts.
If posterior decompression is performed, only one rod is inserted to facilitate access to the spinal canal.
For non-fusion surgeries, consideration should be given to using large diameter rods (4.0 mm) to prevent rod fracture.
5 Fusion top
Life expectancy and performance status should be used to determine whether bone grafting is indicated.
For patients with good prognosis and a long life-expectancy, posterior fusion may optionally be performed using allograft and/or local autograft.
The facet capsule is excised, and the joint cartilage surfaces are denuded/curetted.
Pieces of bone graft (autograft, allograft) are inserted into the decorticated facet joint for fusion.