Executive Editor: Chris Colton

Authors: Florian Gebhard, Phil Kregor, Chris Oliver

Distal femur Extraarticular fracture, wedge

Temporary external fixator

1. Note on illustrations

Throughout this treatment option illustrations of generic fracture patterns are shown, as four different types:

A) Unreduced fracture
B) Reduced fracture 
C) Fracture reduced and fixed provisionally 
D) Fracture fixed definitively

2. Principles of joint-spanning external fixation

A joint-spanning external fixator is fixed to the femur and the tibia while the fracture zone is left virtually untouched (it is bridged). Provisional reduction is achieved with distraction.

Details of exernal fixation are described in detail in the basic technique for application of modular external fixator.

Specific considerations for the tibia and the femur are given below.

Teaching video

AO teaching video: Femur--Tibia Articular Fracture Large External Fixator: Knee-bridging Modular Frame

3. Patient preparation

This procedure is normally performed with the patient in a supine position .

4. Pin insertion (tibia/femur)

Pin placement

For safe pin placement make use of the safe zones and be familiar with the anatomy of the lower leg and the femur.

The safe zone for the femur is lateral. In temporary external fixation, the pins should be placed so that they do not interfere with planned later definitive fixation; this may mean placing femoral pins anteriorly or anterolaterally.

Soft-tissue dissection

In the femur, blunt dissection of the soft tissues and the use of small Langenbeck retractors will minimize muscular damage.

Using a straight clamp, prepare a channel for the insertion of the pin.

Tibial pin placement

Drilling a hole in the thick tibial crest may be associated with excessive heat generation and there is a risk the drill bit may slip medially or laterally damaging the soft tissues. As the anteromedial tibial wall provides adequate thickness for the placement of pins, this trajectory is preferable. A trajectory angle (relative to the sagittal plane) of 20-60° for the proximal fragment and of 30-90° for the distal fragment is recommended.

Alternatively, in order to avoid the frame catching on the opposite leg, the pins may be placed more anteriorly. The drill bit is started with the tip just medial to the anterior crest, and with the drill bit perpendicular to the anteromedial surface (A). As the drill bit starts to penetrate the surface, the drill is gradually moved more anteriorly until the drill bit is in the desired plane (B). This should prevent the tip from sliding down the medial or lateral surface.

5. Frame construction / reduction and fixation (tibia/femur)

Frame assembly

Pearl: oblique distal tube
Angle the rod over the tibia such that it is attached to the pins one on the lateral and one on the medial side. This results in a larger window over the condyle which can be beneficial for later (minimally invasive) surgery if it is necessary to maintain the external fixator during definitive osteosynthesis.

Reduction and fixation

Restore length with a bolster behind the knee to give slight flexion.

It should be understood that a perfect reduction will not be obtained.

Pitfall: Flexion of the articular block

Care must be taken that the fracture is not too distracted, since the pull of the gastrocnemius muscle would hyperextend the condylar block.

Insufficient distraction leads to insufficient reduction.



Contact | Disclaimer | AO Foundation

v1.0 2008-12-03