Executive Editor: Fergal Monsell

General Editor: Chris Colton

Authors: Andrew Howard, James Hunter, Theddy Slongo

Pediatric proximal femur 31-M/7

Open reduction, tension band (greater trochanter)

1. Preliminary remarks


Avulsion of the greater trochanter that disrupts the abductor mechanism can be repaired by open reduction and screw or tension band fixation depending on the size of the avulsed fragment.

A tension band wire technique is a good alternative for smaller fragments.

For children with 4 or more years of growth remaining, it is recommended that implants are removed after fracture healing to allow for growth.

For children with less than 4 years of growth remaining, the implants can be left in place unless symptomatic.

Patient preparation

This procedure is normally performed with the patient in a lateral position .

See also the additional material on preoperative preparation .


The fracture fragment is approached with a lateral approach , the hematoma is evacuated and periosteum is cleared to allow accurate reduction of the fragment(s).

Equipment selection

The following implants are required:

  • 1.6, 2.0, or 2.5 mm K-wires
  • 1.0, 1.2, or 1.4 mm cerclage wire or heavy suture material

2. Reduction

The trochanteric fragment is directly reduced to its bed and the position confirmed using image intensification.

A towel clip may be used for temporary control, or a K-wire can be used to aid manipulation and to provide temporary fixation.

3. Fixation

K-wire placement

Two K-wires are placed superiorly in the trochanter. The trajectory should be perpendicular to the fracture line with one wire slightly anterior and the other slightly posterior. Tips of the wires should just perforate the dense bone of the medial calcar, if possible. The wires may be backed out to allow for later impaction.

If a temporary K-wire has been used, it can now be removed.

Preparation for wire insertion

An anterior to posterior hole is drilled through the lateral metaphysis of the proximal femur using a 2.0 or 2.5 mm drill bit.

Wire preparation and insertion

The cerclage wire is prepared by making a loop approximately one third along its length.

The shorter segment of the wire is inserted through the drill hole.

The long segment of the wire (bearing the loop) is passed in a figure-of-eight configuration, deep to the abductor tendon around the protruding ends of the K-wires.

Pearl: Passing this K-wire can be facilitated by initially inserting a 14-gauge Angiocath in the desired position, removing the metal needle, and passing the cerclage wire though the plastic cannula.

The cerclage wire ends are united with a little twist.

The wire ends are cut short.

The slack is then taken up by further twisting. This is repeated until the desired tension is achieved. Both loops must be tightened at the same time and in the same direction, in order to achieve equal tension on both arms of the wire.

By simultaneously tightening the twist and the loop with two pliers, the two fragments are drawn together such that the fracture is placed under compression.

The twisted wire is trimmed and both ends turned towards the femur in order to prevent subsequent irritation of the soft tissues.

Sinking the K-wires

A plier, bending iron, and forceps are used to bend the K-wires through 180°.

The K-wires are then driven home, sinking their curved ends into the bone in order to prevent backing out.

Alternative: Cortical screw anchor

A 4.5 mm cortical screw can be used to anchor the cerclage wire distally.

Alternative: Nonresorbable suture

A nonresorbable suture can be used as a tension band instead of wires. This may be more suitable in younger patients.


Routine closure according to the surgeon's preference.

4. Postoperative protocol

It is important to avoid active contraction and passive movement of the corresponding muscle. Therefore, good instructions from the surgeon and/or physiotherapist are helpful.

Crutch walking with toe-touch weight bearing, supervised by a physiotherapist, should be advised for 3-4 weeks.

Follow up

Abductor strengthening exercises can be started after 6-8 weeks if there are clinical and radiological signs of healing.



Decision support

Contact | Disclaimer | AO Foundation

v1.0 2017-12-04