Executive Editor: Peter Trafton, Michael Baumgaertner

Authors: Peter Kloen, David Ring

Proximal forearm Radius, extraarticular, avulsion of bicipital tuberosity

Biceps reinsertion

1. General considerations

Timing of surgery

Reattachment of the distal biceps tendon should be performed within a few days of injury. After three weeks the tendon will have retracted and shortened, and the tendon tract will have begun to scar over.

Indication

Surgery is indicated in patients with functional impairment. If the patient needs strength of elbow flexion and forearm supination, repair is usually advisable.

Options

The biceps tendon can be reattached with either a two-incision approach to the proximal radius, or a single anterior approach (limited Henry approach). Make sure to “milk” the biceps inferiorly before inflating the tourniquet. Otherwise the tendon will be too short.

Note: The two-incision approach reduces the risk of radial nerve injury. As a potential disadvantage, it may cause a synostosis.

3. Option 1: Tendon through bone tunnel (two-incision approach)

First skin incision

Make a 4 cm transverse incision in the antecubital crease. Alternatively, a lazy S can be used to allow more exposure (anterior approach).

Identification of the tendon

Identify the biceps tendon and bring it out of the wound. The tendon is often retracted proximally. By flexing the elbow and/or squeezing biceps muscle from proximal to distal the torn end of the tendon presents itself in the wound.

Tendon preparation

The tendon is debrided.

Insert two Nr. 5 nonabsorbable sutures into the tendon, using a crisscrossed locking stitch.

Prepare tunnel for tendon reattachment

Introduce a clamp into the biceps tendon tunnel opposed to the bicipital tuberosity and between the radius and ulna. Advance the clamp until it reaches the skin of the dorsal aspect of the forearm.

Incise the skin over the clamp.

Through the posterior incision, split the common extensor and supinator muscles exposing the bicipital tuberosity of the radius in full pronation.

Radial tuberosity

The radial tuberosity is identified through the posterior incision.

Reattachment preparation

Remove tendon remnants from the bicipital tuberosity to expose bare bone.

Prepare a trough for the tendon. Excavate it with a high-speed burr, under cooling, into a cavity of approximately 10×8mm, and 5 mm deep.

Place three small drill holes on the anterior side of the trough.

Tendon passage

With its attached sutures, bring the biceps tendon through the soft-tissue tunnel from the anterior incision to the posterior incision.

Tendon reinsertion

Suture the tendon into the trough in the bicipital tuberosity. The sutures are placed through the prepared holes as shown.

Check tendon reinsertion during supination and pronation.

4. Option 2: Suture anchors (anterior approach)

Preliminary remark

Alternatively, the biceps tendon can be reinserted into the bicipital tuberosity of the radius with suture anchors through an anterior approach.

Embedding two suture anchors

Create a shallow trough for tendon reinsertion in the bicipital tuberosity with a high-speed burr to expose bleeding cortical bone. Place two suture anchors into the trough as shown.

Tendon reinsertion

Trim the end of the tendon to a smooth fresh surface. Weave the anchored sutures securely, but so they will slide, through the tendon end.

Next, advance the tendon end into the excavated tuberosity, such that it contacts the bone well. Tie the sutures with the forearm in neutral position.

Check the reinsertion site during pronation and supination.

Appendix

Shortcuts

Contact | Disclaimer | AO Foundation

v2.0 2018-04-30