Executive Editor: Chris Colton

Authors: Peter V Giannoudis, Hans Christoph Pape, Michael Sch├╝tz

Femur shaft

back to skeleton

Glossary

Antegrade nailing (trochanteric)
enlarge

General considerations

As a general rule, draping should always be applied up to the pelvic rim, in order to find the correct individual location for the skin incision.

Care should be taken to make the skin incision in line with the curved axis (dashed line) of the femoral canal in order to minimize the risk of injury to the superior gluteal nerve.

Another reason to make the skin incision in line with the bow of the femur is to minimize the risk of eccentric reaming of the proximal fragment, leading to the risk of perforation of the posterior femoral shaft cortex.


enlarge

Correct trochanteric entry point

The correct location for the trochanteric entry point is just next to the tip of the greater trochanter in the AP view. It is important that the entry be exactly centered on the axial view, in order to prevent eccentric reaming.

In unreamed nailing, an incorrect entry point may lead to blow out of either the posterior, or anterior wall of the greater trochanter.


enlarge

Localization of incision

To locate the site of the skin incision, the tip of the greater trochanter and the axis of the femur are marked with the help of the image intensifier and by palpating the trochanter.


enlarge

Image shows palpation with temporary external fixation in place.


enlarge

Incision on the extension of the femoral bow

The 3-5 cm incision should be made 10-15 cm proximal to the tip of the greater trochanter on the proximal extension of the anatomical femoral bow (A). B marks a horizontal line drawn from the top of the greater trochanter, which represents an incorrect skin incision.


enlarge

Skin incision

A 3-5 centimeter incision is made in line with the femoral bow.

(Image shows external fixator used as temporary fixation device.)


enlarge

If in doubt whether to make the incision ten or fifteen cm proximal to the tip of the greater trochanter (eg, in an obese patient), the correct entry point may be assessed with a K-wire and the AP view of the hip.

In cases of morbid obesity it may be necessary to make the incision even further proximally (up to 20 cm).


enlarge

Pitfall: too distal incision

If the incision is too far distal (closer to the greater trochanter), the approach will not be in line with the femoral shaft (red dashed line), and eccentric reaming may lead to weakening of the medial cortex and possibly a blow-out fracture.


enlarge

Deep incision

The fascia is opened with scissors and the gluteus muscle is split along its fibers.

(Image shows external fixator used as temporary fixation device.)


enlarge

Determination of entry point and guide-wire insertion

A finger is inserted to palpate the greater trochanter. The 2.8 mm guide wire, inserted under image intensifier control, enters the medullary canal at a slightly oblique angle. Introduction is manual, using the universal chuck with T-handle.

Verify the entry point by both AP and lateral views with image intensifier.

(Image shows external fixator used as temporary fixation device.)


enlarge

If there is difficulty pushing the guide wire through the cortex of the greater trochanter, the awl can be used to start the track.


enlarge

The soft-tissue track for determination of the entry point should deviate less than 15° from the axis of the femoral shaft in order to avoid any stress on the femoral neck upon insertion of the nail.


enlarge

X-ray showing the correct position of the guide wire.


enlarge

Opening the canal

The cannulated drill bit is passed over the guide wire and through the protection sleeve to open the medullary canal.

(Image shows external fixator used as temporary fixation device.)


enlarge

Image shows opening the canal using the drill bit.

v1.0 2016-10-24