Executive Editor: Steve Krikler

Authors: Paulo Barbosa, Felix Bonnaire, Kodi Kojima

Malleoli

back to skeleton

Glossary

Lateral approach (C-fractures)
enlarge

General considerations

The longitudinal lateral incision is the standard approach for most lateral fractures.

If access to the anterior syndesmosis is required, or a lag screw from anterior to posterior (Chaput lesion) is planned, place the incision slightly anteriorly.

Make a 10-15 cm incision in line with the fibula, centered over the fracture. If necessary, the incision may be extended distally to reduce and hold the syndesmosis.


enlarge

Superficial surgical dissection

The dissection plane is between the peroneus tertius anteriorly and the peroneus longus and brevis posteriorly. The figure shows a long incision, such as would be used for supra syndesmotic fractures.

Handling the damaged soft tissue is crucial. Use small retractors only in good soft-tissue conditions. Retracting with protecting sutures is a safe method.

Note

Be careful not to damage the superficial peroneal nerve, which lies very closely anteriorly, especially in the proximal part of the incision. In more anterior incisions, it should be identified and protected.  When dissecting posteriorly, be careful not to damage the short saphenous vein and the sural nerve.


enlarge

Deep surgical dissection

Free the periosteum at the fracture site. In order to minimize devascularization, reflect only as much of the periosteum as is needed to expose the fracture site. Unnecessary stripping of the periosteum reduces the blood supply of the bone.

If it is necessary to extend the dissection, keep it close to the periosteum, in order to avoid damage to terminal branches of the peroneal artery.


enlarge

Extension to the lateral distal tibia (Volkmann lesion)

If there is a combination of injuries, with a high fibular fracture and a Volkmann tibial fragment, the surgeon may choose to make two separate incisions to address each fragment independently. See Posterolateral approach and Stab incisions for anterior fixation.

Alternatively, the lateral incision may be extended distally to gain access to the Volkmann fragment.

Option 1: Limited exposure

A sizeable Volkmann fragment may be reduced indirectly and fixed with a lag screw from anterior to posterior. When indirect reduction is not anatomical, use a limited posterolateral exposure may be used to reduce and fix the fragment.

Incise the fascia parallel to the posterior border of the distal fibula as far as necessary, avoiding damage to the peritenon of the peroneal tendons.

Retract the peroneal muscles and tendons dorsally and approach the posterolateral edge of the distal tibia directly.

Expose the fracture and elevate the periosteum only sufficiently to control reduction of the dorsal posterior tibial fragment.


enlarge

Option 2: Extended exposure

If the limited exposure is not sufficient for the reduction and fixation of a large Volkmann’s triangle, incise the fascia dorsal to the peroneal muscles at the border of the flexor hallucis longus muscle.

Beware of the sural nerve posteriorly.

Retract the peroneal muscles anteriorly and the flexor hallucis longus and the Achilles tendon dorsally.

Expose the posterior surface of the tibia.

Expose the fracture, and reflect the periosteum only sufficiently to control reduction of the dorsal posterior tibial fragment.


Proximal extension

If the fibular shaft fracture is more proximal, the incision can be made more proximally.

The plane of dissection is the same, but particular care must be taken with the superficial peroneal nerve. In this case it is advisable to identify and protect the nerve.

v1.0 2016-11-15