Executive Editor: Edward Ellis III, Kazuo Shimozato General Editor: Daniel Buchbinder

Authors: J Andreasen, CP Cornelius, N Gellrich, S Hillerup, K Kusumoto, W Schubert

Dentoalveolar Trauma - Tooth fracture, root fracture

back to CMF overview

Glossary

1 Decision/Indication top

Missing coronal fragment enlarge

Almost all root fractures can be treated successfully by timely repositioning and splinting.

If the coronal fragment is missing, and if there are no serious reasons for retaining the apical fragment (which might help maintenance of alveolar volume) it should be extracted. Timing of removal of the remaining root depends on the individual situation of the patient.

2 Repositioning top

Principles

Almost all root fractures can be treated successfully by timely repositioning and splinting.


Cleansing with saline solution enlarge

Repositioning

The exposed root surface of the displaced tooth is cleansed with saline solution.


Repositioned tooth with light axial digital pressure enlarge

The tooth is repositioned with light axial digital pressure until its normal position has been reestablished.

3 Fixation top

Involved teeth are dried with compressed air enlarge

Splint application

Fixation is preferably accomplished with acid etch of the incisal enamel and application of a resin splint involving intact neighboring teeth. The teeth involved are gently dried with compressed air (as illustrated) or absolute alcohol and kept dry during the fixation procedure.

A finger on the lingual aspect of the tooth can maintain tooth position during the fixation procedure.


Etching with phosphoric acid enlarge

Points of fixation in the repositioned tooth as well as neighboring teeth are etched with phosphoric acid for 20 seconds.

Remember to place a suction tube to maintain dryness during etching procedure.


Removal of the etch gel by saline irrigation enlarge

The etch gel is removed by saline irrigation. Make sure to direct the saline jet in a direction away from soft-tissue wounds and to place a suction tube to remove the spray of the saline and etch gel.

The fixation spots are then dried.

It is imperative that the enamel be kept dry until the resin has completely set.


Resin material is applied to provide a splint enlarge

Resin material (eg, used for temporary crowns and bridges) is applied to provide a splint. This material allows a certain flexibility of the splint and is easy to remove.

In the case of a root fracture fixation should remain for 4 weeks.

Note: care is to be taken that there is no occlusal loading to the coronal fragment.


Peeling off of the resin with a dental scaler enlarge

Splint removal

After the fixation period (generally 4 weeks) the resin can be peeled off with a dental scaler or removed with a burr. The tooth must be supported by axial digital pressure during this procedure.

v1.0 2009-12-03