Executive Editor: Chris Colton

Authors: Florian Gebhard, Phil Kregor, Chris Oliver

Distal femur 33-A1.1 Lag screws

back to skeleton

Glossary

1 Principles top

enlarge

Injury types

A1.1-type fractures can result from mild to moderate injury to the knee. Twisting injuries to the knee may result in major ligament disruptions of the medial collateral, or anterior or posterior cruciate ligaments (PCL). It is most commonly the medial collateral (MCL) and the anterior cruciate ligament (ACL) that are injured. Patients with an anterior cruciate ligament disruption will sometimes report a popping sensation from the knee at the time of injury. A rapid early hemarthrosis will develop with an anterior cruciate ligament injury. Anterior cruciate ligament injuries most commonly occur in young patients, who partake in sporting activities. Small A1.1-type avulsion fractures may represent markers or significant injuries to the knee, such as multiligamentous knee dislocation. MRI can detect significant ligament damage. Consultation and advice from specialist knee reconstructive surgeons may need to sought.


enlarge

Pellegrini-Stieda lesion

Long-term effects of avulsion of the medial collateral ligament from its femoral attachment, causing local pain and heterotopic ossification, comprise the “Pellegrini-Stieda” lesion.


Segond fracture

Avulsion of the lateral collateral ligament from the distal femur with a small piece of bone is known as the “Segond” fracture. “Segond” fractures may accompany serious injuries to the knee. There may be peroneal nerve, or menisceal, injuries.

Similar principles apply to the fracture treatment on both the lateral and medial side of the distal femur. In the following we will show the medial A1.1-type injury.


enlarge

Lag screw fixation

The avulsion fracture is reduced and compressed using the lag screw principle.


enlarge

Use of washers to affix ligament

To secure the ligaments and small, thin fragments, a special ligament washer can be used on the screw. These washers are made of either metal, or plastic material.

2 Reduction top

enlarge

Large pointed reduction forceps

Reduce the fracture with a large pointed reduction forceps. Small thin fragments may fracture if such a forceps is applied, and reduction and control with a dental pick may be preferable. The fracture is then secured with a temporary K-wire, taking care not to conflict with the proposed screw track.


enlarge

Drill hole for the lag screw

The forceps are then removed, and the hole for the lag screw is drilled through the center of the avulsed fragment.

3 Fixation top

Lag screw enlarge

Insert a lag screw with or without a ligament washer.

A cannulated screw can be used if available.

Gently examine the knee under anesthesia to test for ligament instability. Be careful not to stress too heavily the reattached ligament.

v1.0 2008-12-03