Executive Editor: Chris Colton, Rick Buckley

Authors: Peter V Giannoudis, Hans Christoph Pape, Michael Sch├╝tz

Femur shaft - Segmental, intact, distal 1/3 fractures

back to skeleton


1 Note on illustrations top


Throughout this treatment option illustrations of generic fracture patterns are shown, as four different types:

A) Unreduced fracture
B) Reduced fracture 
C) Fracture reduced and fixed provisionally 
D) Fracture fixed definitively

2 Principles of modular external fixation top


The modular external fixator is optimal for temporary use. It is rapidly applied without need for intraoperative x-rays and can be adjusted later. If possible the external fixation should be converted to a nail or plate within a week or two, before pin sites become infected. Ensure adequate pin care treatment until frame removal.

Details of external fixation are described in the basic technique for application of modular external fixator.

Specific considerations for the femur are given below.

3 Patient preparation top


This procedure is normally performed with the patient in a supine position with manual traction.

4 Pin insertion (femoral shaft) top


Initial reduction

Prior to pin insertion, it is advisable to correct by manual traction any rotational deformity as well as any overlap of the fracture fragments. By maintaining axial traction, it will be possible to optimize pin placement, thereby facilitating the subsequent reduction maneuvers.


Pin placement

For safe pin placement make use of the safe zones and be familiar with the anatomy of the femur.

The safe zone for the femur is lateral. In temporary external fixation, the pins should be placed so that they do not interfere with planned later definitive fixation; this may mean placing femoral pins a little anteriorly.


Soft-tissue dissection

Blunt dissection of the soft tissues and the use of small Langenbeck retractors will minimize muscular damage.

Using a straight clamp, prepare a channel for the insertion of the pin.


Pin insertion

When applying three pins in each fragment, insert only two pins initially and link with a rod fully loaded with three clamps. After tightening the clamps on the initial two pins, insert the third pin through its relevant clamp. If all three pins are inserted at once, it may prove impossible to link all three to the tube, if they are in slightly different alignments.

5 Frame construction / reduction and fixation (femoral shaft) top


To increase frame stability a neutralization rod should be added.


In distal shaft fractures or supracondylar fractures fixation can be accomplished a) by non-spanning external fixation with two pins in the condyle or b) by joint-spanning external fixation from femur to tibia as described in the distal femur module.

6 Potential postoperative complications top

Loss of reduction

In cases of delayed conversion of the external fixator to a definitive fixation, check x-rays are advisable within the first week and regularly thereafter, to ensure that the quality of reduction has been maintained.

Compartment syndrome

Close monitoring of the femoral muscle compartments should be carried out, especially during the first 48 hours, to ensure that compartment syndrome, requiring decompression by urgent fasciotomy, has not developed.

v2.0 2018-07-05