General Editor: Chris Colton

Authors: Fergal Monsell, Dalia Sepulveda

Pediatric distal forearm 23r-E/4.1

back to Pediatric overview

Glossary

1 Introduction top

enlarge

These are intraarticular fractures and the adult principles of anatomical reduction and stable fixation are also relevant in children.

If closed reduction, with or without the assistance of a percutaneous K-wire, is unsuccessful, open reduction is required. 

Impediments to closed reduction include pronator quadratus, and/or periosteum.

In younger children, fixation can be achieved using a K-wire. A lag screw, totally within the epiphysis, can be used as an alternative near skeletal maturity when the epiphysis is largely ossified. 

Preoperative CT imaging is desirable to determine the exact anatomy of the fracture and, therefore, the correct orientation of any intraepiphyseal implant.

2 Open reduction top

enlarge

Removal of impediments

Soft tissue impediments to reduction are removed.


enlarge

Reduction

After soft tissue impediments have been removed, the fracture will generally reduce directly using a small pointed reduction clamp.


enlarge

Reduction with the help of a K-wire

A single K-wire can be inserted into the epiphyseal fragment and used as a joystick to facilitate reduction.

If this wire is inserted in the direction of the proposed definitive fixation, it can then be advanced across the fracture after reduction has been secured.

3 K-wire fixation top

enlarge

Skin incision

K-wire fixation of the metaphyseal fragment is only justifiable if the fragment is too small to take an implant.

A small skin incision is made for K-wire insertion.

The incision is deepened to the bone using a blunt artery forceps and a protective sleeve inserted.

Care should be taken to avoid the dorsal sensory branch of the radial nerve.


enlarge

Insertion of the intraepiphyseal K-wire

A smooth 1.25-1.6 mm K-wire is inserted through the radial epiphysis in a direction determined by the fracture pattern. The K-wire should ideally cross the fracture plane as near to 90° as the fracture anatomy permits.

The wire should be inserted with an oscillating drill and cooled with saline solution to prevent thermal injury.

The wire may also be inserted by hand using a T-handle.


enlarge

Ideally, the K-wire is inserted using image intensifier control, in order to check the trajectory of the wire.


enlarge

Alternative: Cannulated screw

In the child nearing skeletal maturity an intra epiphyseal lag screw can be inserted. Using the intraepiphyseal wire as a guide, a cannulated screw is inserted over the wire with the appropriate soft-tissue protection, provided the full instrumentation is available.


enlarge

Insertion of a second K-wire

In order to add stability, a second wire is inserted as near as possible to 90° to the metaphyseal fracture line.


enlarge

If the metaphyseal fragment is too small to accept a wire, then a second wire can be inserted through the radial epiphysis, the physis and engaging the medial cortex of the radial metaphysis.


enlarge

Confirmation of reduction

Ideally, reduction should be confirmed using image intensification, or arthrography.


enlarge

The K-wires are left protruding through the skin, bent and cut. The skin is protected with sterile padding prior to application of a cast.

The illustration demonstrates the use of a small section of plastic tubing over the cut ends of the protruding wire. This adds further protection for the skin.

Note: Excessive pressure between dressing and skin should be avoided to prevent skin necrosis.

4 Short arm cast top

enlarge

General considerations

The purpose of the cast is protective and for pain relief, as stability is provided by the K-wire(s).

The short arm cast is applied according to standard procedure:

Note: In young, small, or noncompliant patients, it is safer to apply a long arm cast.


enlarge

Splitting of cast

If a complete cast is applied in the acute phase after injury, it is safer to split the cast down to skin over its full length.

5 Long arm cast top

enlarge

In the event that a long arm cast is necessary (see above) it is applied and split according to standard procedure.

v1.0 2016-12-01