1 Introduction topenlarge
These fractures are usually posteriorly angulated (apex anterior) and whilst they can generally be reduced closed, occasionally impediments to reduction include periosteum and/or pronator quadratus.
Anteriorly angulated (apex posterior) fractures are less common and are also generally reduced closed, but the extensor tendons occasionally impede reduction.
If closed reduction is unsuccessful, open reduction is indicated.
2 Open reduction top
As the majority of these fractures are posteriorly displaced, open reduction is most commonly performed via the anterior approach.
A posterior approach may occasionally be necessary for irreducible anterior displacement.
Removal of impediments
Soft tissue impediments to reduction are removed, eg, pronator quadratus as in the illustration.
Once the soft tissue impediments have been removed, the fracture can be reduced under direct vision.
Direct reduction using a K-wire
A K-wire is inserted at the fracture site and used as a lever to facilitate reduction of either bone.
3 Plate fixation topenlarge
For anteriorly displaced fractures, a simple buttress technique is used confining screw insertion to the proximal fragment.
The plate acts as a buttress against further anterior displacement and is usually sufficient.
As the majority of these patients are approaching skeletal maturity, if additional stability is required screws may be inserted into the distal fragment, if necessary crossing the physis.
Provisional K-wire fixation
The fracture is provisionally fixed using a single, or two crossed, smooth 1.6 mm K-wire(s) through the radial metaphysis avoiding the growth plate and the perichondrial ring, if possible.
Application of distal radial plate
The longitudinal portion of the plate is applied to the bone. The distal end of the plate should reach just proximal to the edge of the radial articular surface.
Smaller implants are available for younger children.
If in doubt the position of the articular surface can be demonstrated with an arthrogram.
Insertion of the first screw
A screw is inserted through the most distal plate hole overlying the proximal radial fragment.
The plate position is checked using intraoperative imaging and/or arthrogram, and the screw is then tightened.
Insertion of additional screws
When the plate has been used in buttress mode, the proximal fixation is then completed by the insertion of additional screws into the proximal fragment.
For unstable, posteriorly displaced fractures, the distal fragment is secured with screws through the transverse portion of the plate.
Once the plate fixation is complete, the provisional K-wires are removed.
4 Short arm cast topenlarge
The purpose of the cast is protective as stability is provided by the plate.
The short arm cast is applied according to standard procedure:
Splitting the cast
If a complete cast is applied in the acute phase after injury, it is safer to split the cast down to skin over its full length.