1 Introduction topenlarge
The ESIN method involves closed reduction and internal fixation with an elastic nail.
This method is a commonly used treatment option for displaced and/or unstable fractures of the forearm and can be used in any age group.
ESIN without image intensifier
ESIN method is possible without an image intensifier or peroperative x-ray examination.
The procedure is modified to include direct visualization of the fracture with an open approach. Stripping of the periosteum and disruption of the fracture hematoma are disadvantages.
2 Instruments and implants topenlarge
Instrument set for ESIN
- 1.5-2.5 and occasionally 3.0 mm elastic nails
- Alternatively: 30 cm long, 1.6-2.5 mm K-wires with the tip bent
- Awl or drill
- Nail cutter
- Small hammer
- Optional: end caps
The end cutter is useful to avoid sharp ends and soft-tissue irritation.
Use of K-wires
Ring fixator wires may be used.
Bend the tip by approximately 30° to provide a gliding aid.
For optimal reduction and intramedullary three-point fixation, the nail diameter should be between 60% and 70% of the medullary canal.
3 Technique top
Preliminary reduction is not useful as deformity often recurs following manipulation.
The proximal lateral entry point is in common use and shown in this procedure.
The distal medial entry point is an alternative and useful in midshaft and proximal 1/3 fractures of the ulna.
Opening the canal
Use small scissors or a surgical clip and small retractors to dissect to the bone under direct vision.
Place the awl or drill directly to the bone and perforate the near cortex, under direct vision, perpendicular to the bone.
Do not hammer the awl to avoid perforation of the far cortex.
When the medullary canal is reached, lower the awl or drill 45° to the shaft axis and advance it with oscillating movements to produce an oblique canal.
Pitfall: Entry point through the olecranon
Do not introduce the nail through the olecranon.
This does not enhance fixation and causes troublesome soft-tissue irritation.
Precontouring the nail for forearm shaft fractures may be required.
The medullary canal is small, and the nail may deform during insertion.
Fix the nail into the inserter and pass it into the canal.
Pearl: insertion of nail tip perpendicular to shaft
Insert the nail with the tip perpendicular to the shaft axis until the far cortex is felt. Rotate the nail 180° and advance it using the curved side of the tip as a gliding aid.
If the tip is stuck in the far cortex and cannot be advanced, remove the nail and bend the tip to give a slightly more pronounced curvature.
Advancing the nail
Advance the nail to the fracture site with an oscillating maneuver.
Reduce the greenstick deformity and advance the nail into the distal fragment, down to the strong metaphyseal bone at the level of the distal ulna.
Pearl: A short working length (3-5 cm) between the entry point and the inserter improves control of the nail during insertion.
Pitfall: iatrogenic fracture
In young children, the nail tip may become stuck because of the narrow medullary canal.
Do not use a hammer if the nail is stuck as this risks iatrogenic fracture.
Withdraw by 2 cm, rotate the nail to free the tip and continue advancing.
Pearl: estimation of nail length
If an image intensifier is not available, estimate the optimum nail length with a second identical nail placed parallel to the initial nail.
Rotate the nail to counteract the deformity and anchor the tip in the cortex.
Cutting the nail and wound closure
Cut the nail near the bone.
If a dedicated nail cutter is not available, cut the nail slightly shorter as the end will be sharper and this prevents skin perforation.
Gently withdraw the nail by 1 cm, cut the nail outside the skin and reinsert to the original position with an impactor.
Close the subcutaneous tissue and skin in a standard manner.
4 Option: end caps topenlarge
End caps may be useful for stabilizing length unstable fractures.
The nail should finally be advanced using the beveled impactor.
A small end cap can be screwed in over the nail using the inserter.
5 Final assessment topenlarge
Check the completed osteosynthesis with image intensification. These images should be retained for documentation or alternatively an x-ray should be obtained before discharge.
Make sure that the desired reduction has been achieved and the nail is of appropriate length.