Executive Editor: Steve Krikler

Authors: Renato Fricker, Jesse Jupiter, Matej Kastelec

Distal forearm 23-B1.3 Cast

back to skeleton

Glossary

1 General Principles top

Cast treatment is recommended and reliable for:

  • undisplaced or minimally displaced intraarticular fractures
  • unstable fractures in some low demand patients (when some degree of malunion may be tolerated)

How to make it work:

  • exclude unstable fracture patterns
  • recognize deformity and correlate to mechanism of injury
  • use adequate analgesia
  • obtain a good reduction before applying the cast
  • meticulous casting technique
  • do not immobilize in extreme positions
  • careful early follow-up (x-rays and clinical)

Casting in low demand patients

It may not be possible to maintain reduction of a fracture in a cast, but a cast may be useful as a splint to help relieve pain.

2 Reduction top

Cast treatment is recommended and reliable for:

  • undisplaced lunate facet fractures
  • moderately displaced fractures in some low-demand elderly patients (when some degree of malunion may be tolerated)

3 Below elbow cast top

Imaging

It is advisable to confirm that the fracture is in an acceptable position before applying the cast. This may require image intensifier.


Purpose

The cast used in the nonoperative treatment of the majority of distal radial fractures is a below elbow cast. If the ulna is involved, a sugar tong or an above elbow cast may be considered, in order to control forearm rotation.


enlarge

The purpose of a cast is to maintain the fracture reduction or prevent displacement, but ideally while minimizing the functional effect on the limb.


Care must be taken not to immobilize joints in a position which interferes with long term function, wherever possible.


enlarge

Applying a cast

The assistant holds the thumb fully extended with one hand. The other hand holds the radial two/three fingers (avoiding cupping of the hand) maintaining slight traction, with ulnar deviation at the wrist.

If Chinese finger traps have been used instead of an assistant, the cast may be applied before the finger traps are released.


enlarge

The initial cast should either be a backslab or a split cast to allow for swelling.

Distal perfusion should be checked at all stages of this procedure and continually monitored after cast completion.

In most fractures, the cast is maintained for 4-6 weeks. Once the initial swelling has subsided, the cast is changed with careful maintenance of position. It may be prudent to obtain a check radiograph in the new cast to make sure that no displacement occurred as the cast was changed.


In fractures which had significant displacement, even if well reduced in the initial cast, there is a significant risk of subsequent displacement and they should be monitored carefully with radiographs at one and two weeks.

Although a fracture may be remanipulated within two weeks of the injury, if a fracture displaces in a cast, the deformity should either be accepted or the fracture might be better managed with ORIF.


enlarge

Pearl

The joints at each end of the cast must be left free to move during the period of casting. Avoid extending the cast too close to the elbow anteriorly (which prevents elbow flexion). Pay particular attention to leaving the metacarpophalangeal joints (MCPJs) free. Failure to do this will result in capsular contracture and loss of MCPJ flexion.

The patient should be encouraged to extend the fingers and make a fist many times daily.


enlarge

Pitfall: positional errors

Avoid extremes of any position. Particular difficulties will be encountered if the wrist is immobilized in extreme radial/ulnar deviation and/or flexion.


Monitoring

All patients in a cast should be monitored for pain, swelling, altered sensation or perfusion.

4 Other Casting Options top

A simple forearm cast cannot control pronation and supination. If it is felt important to limit supination and pronation movement in the forearm, for example in ulnar fractures, it is necessary to extend a forearm cast proximally, either by the use of a sugar tong cast or an above elbow cast.


enlarge

Sugar tong cast

A sugar tong cast is indicated in injuries of the DRUJ, A1.2/3 fractures and all radial fractures associated with this type of ulnar fracture, if there is concern about any possible displacement.


enlarge

A sugar tong splint may be used for the first 2-3 weeks only. It prevents forearm rotation by immobilizing the distal radioulnar joint (DRUJ), yet allows some elbow flexion/extension, thereby preventing elbow stiffness.


enlarge

It should be applied with elastic wrapping to allow for soft-tissue swelling.

2016-10-17