Executive Editor: Peter Trafton

Authors: Kodi Kojima, Steve Velkes

21-A2.2 ORIF

back to skeleton

Glossary

1 General considerations top

enlarge

Lag screw principles

In oblique fractures of the radial neck, fixation is achieved by lag screws. Longer oblique fractures allow two screws. This is more secure, and should be preplanned.

The thread pulls the opposite bone fragment towards the head of the screw, placing the fracture ends under compression. The portion of the thread in the gliding hole does not purchase in the surrounding bone. Insert the lag screw(s) as perpendicularly to the fracture plane as possible.

Note
Lag screw fixation may prove unsatisfactory for short oblique fractures of the radialneck. If so, plate fixation may be required.


Choice of implant

Mini fragment 1.5 mm, 2.0 mm, or 2.7 mm screws are used.

2 Reduction and provisional fixation top

enlarge

Expose the fracture ends with minimal soft tissue dissection off the bone.

Remove hematoma and irrigate.

Reduction is direct, aided by supination-pronation of the forearm. Reduce and provisionally fix the fracture with the help of small pointed reduction forceps.

3 Lag screw insertion top

enlarge

Drilling

Drill a gliding hole (sized according to chosen screw size, see fig.) for the lag screw into the proximal fragment.

Insert the appropriate drill sleeve into the gliding hole until it reaches the far cortical bone.

Now drill the far cortex with the appropriate drill bit.


enlarge

Measuring

Measure the depth of the hole with the hook of the depth gauge pointing distally. Tap the far cortex with the appropriate cortical tap, using the protection sleeve.

Note
Always tap after measuring in order not to destroy the thread.


enlarge

Lag screw insertion

Closely observe the compression effect on the fracture line while tightening the lag screw.

The reduction forceps should be removed just before the final tightening of the screw.


enlarge

Second lag screw

If the fracture configuration allows the insertion of a second lag screw, it can be inserted now, using the same technique as described above.


Final assessment

Finally, assess the range of motion in pronation, supination, flexion and extension. Fixation should be stable and crepitus or restricted motion should be absent.

Check fracture and screws with image intensifier or x-ray.

v1.0 2007-10-14