Executive Editor: Joseph Schatzker

Authors: Jonas Andermahr, Michael McKee, Diane Nam

Scapula Glenoid fossa, partial articular, anterior multifragmentary

back to skeleton


1 Principles/Introduction top


In a multifragmentary fracture of the glenoid fossa, the small fragments are often too small to fix with the standard 3.5 conventional/cannulated screws. Typically, the following mini-fragment screws are then used:

  • Conventional 2.0 or 2.7 lag screws
  • Headless 2.4 screws (cannulated)

Headless screws are preferable where fixation involves putting them through capsule or labrum. 

In addition, they are the smallest cannulated screw system.


In fractures of the glenoid rim where the glenoid fragments are too small to fix with screws, the glenoid labrum still needs to be reduced and fixed to obtain a stable shoulder. This can be performed using suture anchors.

2 Patient preparation top

This procedure may be performed with the patient in either a beach chair position or supine position.

3 Approach top


Anterior fractures are reduced and fixed through the deltopectoral approach.

4 Reduction top


One K-wire is partially inserted in the main fragment and is used as a joystick for reduction. If conventional screws are to be used for fixation, make sure that the fragment is big enough to take the head. Otherwise use the headless screw. 

K-wires and screws must be extra articular.


When reduction is completed, insert the K-wires further to secure temporary fixation of the fracture.


The size of the fragments determines their fixation. At times, if the fragment is very small, a K-wire will serve as its definitive fixation. Otherwise, use either the headless screw or the small fragment cannulated screws.

Depending on the size of the main fragments, one or two appropriate length screws are then inserted…


… and the K-wires are removed. Smaller fragments may be keyed into place and held by the larger fragments.

Sometimes one must resort to an anchor if the fragment is very small as well as a small spring plate.


Use the image intensifier to check your reduction prior to any definitive fixation. At the end, check once again with the image intensifier to make sure that there is no intra articular metal.