General Editor: Luiz Vialle

Authors: Ilya Laufer, JJ Verlaan (on behalf of AOSpine Knowledge Forum Tumor)

Spine tumors Subaxial cervical, stable, high ESCC

back to Spine overview

Glossary

1 Introduction top

Preoperative planning

Based on CT and MRI imaging, a plan should be prepared to determine:

  • The size and optimal location of implants used
  • Whether spinal cord decompression is necessary and if so, the amount of tissue to remove in order to achieve sufficient spinal cord decompression

Every case will be unique, and we will here illustrate just one example.


enlarge

The cervico-thoracic junction

The cervico-thoracic junction has a specific biomechanical behavior. This is due to the sudden change from the extremely flexible cervical spine, to the more rigid thoracic spine.

The thoracic spine has a shorter elastic zone due to:

  • the rigid rib cage.
  • the coronal orientation of the facet joints.
  • the overlapping of the spinous processes.

Biomechanically the cervico thoracic junction is vulnerable to kyphosis and shear forces. Usually a long construct (2-3 levels above and 2-3 below the tumor) is necessary to achieve adequate stability. That is why the anterior alone constructs at this level are not recommended because of high-failure risks.

The anterior approaches might be difficult because of complex anatomy involving numerous essential anatomical structures at this level.


Use of dexamethasone

Administration of dexamethasone (10 mg bolus, 4 mg every 6 hours) is recommended as soon as ESCC causing neurologic deficit is diagnosed. Dexamethasone should be stopped or tapered as soon as spinal cord decompression is completed.


Embolization

Embolization procedures are recommended to reduce operative blood loss in hyper vascular tumors, especially for larger resections.


Neurological evaluation

The preoperative neurological assessment must be carried out as described in the Neurological Evaluation.

2 Patient positioning and surgical approach top

enlarge

For this procedure the patient is placed in the prone position and the posterior access to the cervicothoracic junction is used.

3 Screw insertion top

enlarge

In tumor patients achieving optimal screw purchase is even more important than in trauma patients to minimize risk of pullouts and reduce the number of levels involved.

Optimal pedicle screw purchase will, in order of importance, be achieved by:

  1. Selecting the largest possible screw diameter
  2. Selecting the longest possible screw
  3. Positioning of the screw under the cranial endplate
  4. Cement augmentation of the screw.

enlarge

Cervical screws

In the lower cervical levels, the following screws can be used:

Due to safety, lateral mass screws are preferred from C3 to C6. If the lateral mass is compromised an additional level can be included in the fixation or pedicle screws may also be considered.

A lateral mass screw can also be used at the level of the tumor if the lateral mass is intact.


enlarge

Thoracic screws

In the upper thoracic spine, the following screws can be used:

If the pedicles are too small (extremely rare for the T1 level), an outside-inside technique or laminar screws can be used as an alternative at the level of T1-T2.

4 Rod insertion top

enlarge

Rod selection

Double diameter tapered rods can be used if available. In this case no rod connectors are needed.

This is the preferred option as it is easier to install and reduces operating time compared to other constructs. Alternatively, stabilization of the cervicothoracic junction can be performed with a cervical system provided 4.0mm rods and pedicle screws are available.


enlarge

Rod contouring

Rod contouring should mainly follow the curvature of the spine. Reducing preexisting deformities is typically not necessary and may lead to screw pull-out.


enlarge

Rod insertion

The rod is inserted into the screw heads and the screw heads are tightened with the inner nuts.

If posterior decompression is performed, the insertion of only one rod can facilitate access to the spinal canal. To illustrate this procedure, we will show the decompression with only the first rod in place.

5 Decompression top

Timing of decompression

A patient who is experiencing neurologic deficit from solid tumor ESCC resulting in loss in ability to ambulate, in the absence of medical and oncological contraindications, requires urgent surgical decompression.

Expeditious diagnosis and prompt surgery are recommended to improve the probability of neurological recovery.


enlarge

Decompression

A laminectomy is performed in the area between the pedicles of the vertebra.

Based on preoperative planning, the amount of lamina to be removed to achieve enough decompression can be determined beforehand.


enlarge

Remove the spinous process and the lamina in one piece.


enlarge

The adjacent spinous processes and the intervening ligamentum flavum are excised.

Portions of the superior and inferior lamina and the medial portion of the facet joint are removed.


enlarge

The posterior longitudinal ligament (PLL) should be identified and separated from the dura with a dura dissector.


enlarge

The PLL should be cut in order to expose the vertebral body and the epidural tumor. This circumferential spinal cord decompression technique coupled with postoperative SBRT is known as separation surgery.

The spinal cord, dura, and tumor should be manipulated as little as possible.


enlarge

Reverse-angle curettes and pituitary rongeurs can be inserted through this opening, and any tumor and bone fragments compressing the anterior neural elements can be removed or impacted into the vertebral body.


enlarge

If further decompression is needed, the same technique may be applied on the other side.

If the decompression is adequate on both sides of the canal, the second rod may be fixed and tightened.

6 Fusion top

Decision

Live expectancy and performance status should be used to determine whether bone grafting is indicated.

For patients with good prognosis and a long life-expectancy, posterior fusion may optionally be performed using allograft and/or local autograft.


enlarge

Fusion

If the surgeon plans for a fusion, the facet capsule is excised and the joint cartilage surfaces are denuded/curetted.


enlarge

Pieces of bone graft (autograft, allograft) are inserted into the decorticated facet joint for fusion. 

7 Postoperative imaging top

enlarge

Postoperative AP views should be obtained. As lateral views are not available in this area, a CT scan should be obtained as soon as possible after surgery to confirm the placement of the instrumentation.

V1.0 2019.01.06