General Editor: Luiz Vialle

Authors: Ilya Laufer, JJ Verlaan (on behalf of AOSpine Knowledge Forum Tumor)

Spine tumors Subaxial cervical, unstable, high ESCC

back to Spine overview

Glossary

1 Introduction top

Preoperative planning

Based on CT and MRI imaging, a plan should be prepared to determine:

  • The size and optimal location of implants used
  • Whether spinal cord decompression is necessary and if so, the amount of tissue to remove in order to achieve sufficient spinal cord decompression

Every case will be unique, and we will here illustrate just one example.


Use of dexamethasone

Administration of dexamethasone (10 mg bolus, 4 mg every 6 hours) is recommended as soon as ESCC causing neurologic deficit is diagnosed. Dexamethasone should be stopped or tapered as soon as spinal cord decompression is completed.


Embolization

Embolization procedures are recommended to reduce operative blood loss in hyper vascular tumors. , especially for larger resections.


Neurological evaluation

The preoperative neurological assessment must be carried out as described in the Neurological Evaluation.

2 Patient positioning and surgical approach top

enlarge

Preoperative planning

For this procedure the patient is placed in the prone position and the posterior approach to the cervical spine is used.

3 Instrumentation top

enlarge

Posterior instrumentation should normally include two levels above and two to three below the affected vertebra.


enlarge

C1 fixation

If C1 instrumentation is indicated lateral mass screws are used.


enlarge

C2 fixation

For C2 fixation the following options are available (in order of preference):

A consideration is given to use pedicle or laminar screws when doing an occiput to C2 fusion as oftentimes the starting point for the pars screws may compromise the facet joint.


enlarge

Lateral mass screws vs. pedicle screws C3-C7

Fixation can be achieved with either lateral mass screws, pedicle screws or combination of the two.

Because lateral mass fixation is generally sufficient, and carries less risk, pedicle screw fixation is limited to rare cases where lateral mass fixation would be insufficient or not possible. A pedicle screw is most often used in C7 if instrumented.

4 Rod insertion top

enlarge

The rod should be bent to align with the lordosis achieved during positioning.

The rod is inserted into the screw heads and the screw heads are tightened with the inner nuts.

If posterior decompression is performed, only one rod is inserted to facilitate access to the spinal canal.

For non-fusion surgeries, consideration should be given to using large diameter rods (4.0 mm) to prevent rod fracture.

5 Decompression top

Timing of decompression

A patient who is experiencing neurologic deficit from solid tumor ESCC resulting in loss in ability to ambulate, in the absence of medical and oncological contraindications, requires urgent surgical decompression.

Expeditious diagnosis and prompt surgery are recommended to improve the probability of neurological recovery.


enlarge

Technique

A laminectomy is performed in the area between the pedicles of the vertebra.


enlarge

Excise the adjacent spinous processes and the intervening ligamentum flavum.


enlarge

Remove the superior and inferior lamina, and the medial portion of the facet joint.

Based on preoperative planning, the amount of lamina to be removed to achieve enough decompression can be determined beforehand.


enlarge

The posterior longitudinal ligament (PLL) should be identified and separated from the dura using a dura dissector.


enlarge

The PLL should be cut to expose the vertebral body and the epidural tumor.

This circumferential spinal cord decompression technique coupled with postoperative SBRT is known as separation surgery.

The spinal cord, dura, and tumor should be manipulated as little as possible.


enlarge

Reverse-angle curettes and pituitary rongeurs can be inserted through this opening, and any tumor and bone fragments compressing the anterior neural elements can be removed or impacted into the vertebral body.


enlarge

If further decompression is needed, the same technique may be applied on the other side.

If the decompression is adequate on both sides of the canal, the second rod may be inserted and tightened.

6 Fusion top

Life expectancy and performance status should be used to determine whether bone grafting is indicated.

For patients with good prognosis and a long life-expectancy, posterior fusion may optionally be performed using allograft and/or local autograft.


enlarge

Fusion

The facet capsule is excised, and the joint cartilage surfaces are denuded/curetted.


enlarge

Pieces of bone graft (autograft, allograft) are inserted into the decorticated facet joint for fusion.

V1.0 2019.01.06