Executive Editor: Peter Trafton

Authors: Martin Hessmann, Sean Nork, Christoph Sommer, Bruce Twaddle

Distal tibia 43-C3 CREF

back to skeleton

Glossary

Author: Dankward Höntzsch

1 Note on illustrations top

enlarge

Throughout this treatment option illustrations of generic fracture patterns are shown, as four different types:

A) Unreduced fracture
B) Reduced fracture 
C) Fracture reduced and fixed provisionally 
D) Fracture fixed definitively

2 Principles of joint-bridging modular external fixation top

enlarge

The modular external fixator is optimal for temporary use. It is rapidly applied without need for intraoperative x-rays and can be adjusted later.

The joint-bridging modular external fixator for distal tibial fractures consists of two partial frames, one along the tibia and one medial on the calcaneus or calcaneus and talus.

Details of external fixation are described in the basic technique for application of modular external fixator.

Specific considerations for joint-bridging modular external fixation, the distal tibia and the foot are given below. 

3 Pin insertion (tibia and foot) top

enlarge

Pin placement

For safe pin placement make use of the safe zones and be familiar with the anatomy of the lower leg and the foot.


enlarge

Choice of tibial pin placement

Drilling a hole in the thick tibial crest may be associated with excessive heat generation and there is a risk the drill bit may slip medially or laterally damaging the soft tissues. As the anteromedial tibial wall provides adequate thickness for the placement of pins, this trajectory is preferable. A trajectory angle (relative to the sagittal plane) of 20-60° for the proximal fragment and of 30-90° for the distal fragment is recommended.


enlarge

Alternatively, in order to avoid the frame catching on the opposite leg, the pins may be placed more anteriorly. The drill bit is started with the tip just medial to the anterior crest, and with the drill bit perpendicular to the anteromedial surface (A). As the drill bit starts to penetrate the surface, the drill is gradually moved more anteriorly until the drill bit is in the desired plane (B). This should prevent the tip from sliding down the medial or lateral surface.


enlarge

Pin placement in the foot

For the construction of the partial frame of the foot the following three options are used most frequently:

  • one pin in the calcaneus (green circle) and one in the talus (brown circle)
  • two pins in the calcaneus (green and orange circle)
  • one pin in the calcaneus (green circle) and one in the cuboid (blue circle)

4 Frame construction / reduction and fixation (ankle) top

enlarge

Reduction

Reduce the fracture by manipulating the partial frame of the foot and ligamentotaxis. After checking correct reduction with image intensification, fix the reduced position by tightening all clamps.


Fixation of a fibular fracture

Fixation of an associated fibular fracture adds stability and contributes to overall reconstruction. However, the possibility of additional soft-tissue injury must be considered before undertaking this step.

v1.0 2016-11-22