Executive Editor: Ernst Raaymakers, Joseph Schatzker, Rick Buckley

Authors: Matthias Hansen, Rodrigo Pesantez

Proximal tibia 41-A1.2 Direct reduction

back to skeleton

Glossary

1 Principles top

enlarge

Pulling force of the patellar tendon

Due to the pulling force of the patellar tendon most of these fractures are displaced as shown here and need to be reduced. Reduction may be achieved by extending the knee. If this is not enough consider pushing the fragment into place with a ball-spiked pusher.

Reduction is not necessary in undisplaced fractures.


enlarge

Knee flexion

To lessen the possibility of damaging the popliteal neurovascular structures when you drill the proximal tibia in an anteroposterior direction flex the knee at least 15-20 degrees. In full extension the neurovascular bundle is closer to the bone.


enlarge

Countersinking

There are two important reasons for countersinking:

  1. To produce a lower profile of the screw head and thus avoiding soft-tissue irritation.
  2. Countersinking also ensures that the screw head has a maximum contact area with the bone, which leads to an even distribution of forces between the screw head and bone.

 

2 Open reduction top

enlarge

Use of clamp

After direct exposure of the avulsed tibial tuberosity in an open procedure, reduction may be achieved by using a small clamp placed on the anterior tibial cortex and the bone fragment. The reduction may additionally be secured by temporary K-wires.


enlarge

Alternative: ball-spiked pusher

A ball-spiked pusher might also be used for the reduction.

3 Fixation top

enlarge

Lag screw application

Fixation of the tibial tuberosity is achieved by lag screw fixation in an anterior–posterior direction through the main fragment.
Cancellous screws are better in younger patients with solid cancellous bone. These screws are usually left in place after fracture healing.
In elderly people with osteopenia fully threaded screws should be used. Perforation of the posterior tibial cortex should be limited and visualized under image intensifier to avoid damage of nerves and vessels in the popliteal fossa.

Click here for further details on lag screw application.


enlarge

One should never rely on the lag screw fixation alone since the heads of the screws could easily cut out through the bone and fixation would be lost. Therefore, protect your lag screw fixation with a tension band as illustrated.


enlarge

Alternative: tension band wiring

A safe alternative in case of relatively small tibial tuberosity fragment or in case of comminuted fractures is tension band wiring.

The cerclage wire is introduced through the Sharpy-fibers at the insertion of the patella ligament in the tibial tuberosity. K-wires provide rotational stability, are introduced through the proximal part of the tibial tuberosity and should engage the posterior cortex of the tibia.

v2.0 2010-05-15