enlarge

Positioning in undisplaced fractures

In undisplaced fractures, reduction is not necessary. The plaster cast will be applied on the hanging leg (knee flexed to 90 degrees and ankle held at 90 degrees).


enlarge

Application of the padding

First, apply the padding. This needs to be thicker over the malleoli and around the fibular head.


enlarge

The cast should reach from the MTP joints of the toes to just below the knee joint, avoiding the top of the plaster being at the level of the neck of the fibula, where the common peroneal nerve crosses.


enlarge

Handling of plaster bandages

It is important to hold the plaster rolls correctly during application, so that they can be rolled on, rather than pulled on.


enlarge

Application of plaster bandages

It is easier to start proximally, overlapping by half the width of the roll and moving down the lower leg to around the ankle and foot.


enlarge

After the application of the second roll, whilst the plaster is still soft, final manipulation is done and the reduction held, with appropriate molding, until the plaster hardens. This may take 4 to 5 minutes, depending on the temperature of the water – colder water gives you more time.

The final two rolls are then applied, and further molding is performed to achieve the desired 3-point fixation.


enlarge

Molding of the cast: 3-point cast fixation

When molding the cast, the same action as for reduction is repeated and held until the plaster is firm.

The principle of 3-point fixation within the cast needs to be applied. The two main molding points are created by gentle pressure over the medial hindfoot and above the lateral supramalleolar part of the lower leg.


enlarge

The third point is created by molding the upper end of the cast around the leg, over the medial aspect of the leg.